New Designz Spyder HP Valve

The high performance balanced (HP) Spyder valve has great features that sets it apart from any other valve.

Features:

• The HP valve stem has slots on top and bottom. This provides uniform airflow and pressure on the valve stem to the valve body during firing
• The HP valve stem cup seal is tapered for improved air flow
• Fully CNC machined from stainless steel with a replaceable Delrin valve stem cup seal
• The HP valve stem has an undercut section that leads to a 30 degree angle which directs the air into the exhaust side of the valve during firing
• The inlet port has a leading edge that is angled to further enhance airflow
• Common increases average around 47fps, however its not uncommon to see 54+fps using this valve
• With such chronograph or FPS increases, the use of lower pressure springs will help reduce kick and offer less fatigue and wear on marker components
• Markers with inline regulators will be able to significantly reduce the input pressure
• Increases efficiency
• This will work on all Spyders EXCEPT VS Spyders

NOTE: The addition of a low tension spring or spring kit may be necessary to achieve below 300fps operation. As a baseline, markers with inline regulators should be able to drop input pressures around 100psi.